Filter
Top Products
38
Chapter4
Maintenance Mode
Soft SW Setting Mode
Set item Initial value Setting value Remarks
Set item Initial value Setting value Remarks
Set item Initial value Setting value Remarks
The receiving buffer size is selected.
Selects enabled (ENB)/disabled (DIS) of the printer
initialized signal (PRIME) during centro-interface.
Selects enabled (ENB)/disabled (DIS) of the 25pin reset
signal during serial interface.
Selects buzzer sound when an abnormality occurs as
enabled (ON)/disabled (OFF).
Sets the baud rate of the serial interface.
Sets the character length of the serial interface.
Sets the communication parity of the serial interface.
Sets the stop bit of the serial interface.
Selects the paper size.
Selects the cutter operation.
When it is OFF, the FULL/PAR. commands do not start
cutting.
In FREE status, cutting is done according to the
FULL/PAR. commands.
In FULL status, full cut is always done by both the
FULL/PAR. commands.
In PAR status, partial cutting is always done by both the
FULL/PAR. commands.
Selects the color function.
During OFF, the change color command is ignored.
Mechanical-SW
Interface-SW (Displayed only when the serial board is mounted)
40byte
4Kbyte
ENB
DIS
ON
OFF
4k
ENB
ON
9600
8 bit
NONE
1 bit
DTR
76.2
PAR.
ON
Buffer Size
Init Signal
Buzzer
Baud Rate
Data Length
Parity Bit
Stop Bit
Protocol
Paper Width
Auto-Cutter
Color Ribbon
19200
9600
4800
2400
1200
8 bit
7 bit
NONE
EVEN
ODD
1 bit
2 bit
DTR
X-ON-OFF
76.2
69.5
57.5
OFF
FREE
FULL
PAR.
ON
OFF