Filter
Top Products
37
Setting Mode Table
Soft Control-SW
Maintenance Mode
Set item Initial value Setting value Remarks
Command Type EPSON EPSON
STAR
CBM1
CBM2
Number of Col. 40/33 40/33
42/35
Font Select 7x9 7Ω9
9Ω9
Paper Plies OFF OFF
2P
3P
Paper End ENB ENB
DIS
Paper Near-End ENB ENB
DIS
Slashed Zero OFF OFF
ON
Print Direct. BI-DIR BI-DIR
UNI-DIR
Auto LF OFF OFF
ON
Code Page 437
850, 860
863, 865
852, 866
857, 858
WPC1252
The emulation is selected from EPSON/STAR/
CBM1/CBM2.
The initial font size is selected immediately after the
power is turned on.
It sets whether or not slash is used with the numeral 0
(zero).
Copy mode is selected.
OFF/2P/3P can be selected. But when 3P is set, the
printing speed is low.
Designates printing direction. When BI-DIR is selected,
printing starts from the closer of the left and right ends
of the next printing line from the print stop location.
During UNI-DIR printing is usually done from the left end.
The PE signal enabled/disabled is set at paper end when
only the centro-interface is set as enabled. During
enabled status, BUSY, PE, FAULT are output and printing
stops at paper out. During disabled status, only BUSY is
output and printing stops at paper out.
The code page is selected.
Number of full dot in full column is 200 dots. For the
number of line columns based on the paper width, see
“Setting the Paper Width and Printing Line Column Number”.
The LF operation during CR code reception is selected.
When ON, LF does not operate; when OFF, LF operates.
CR: Carriage Return LF: Line Feed
The PE signal enabled/disabled is set at paper near end
when only the centro-interface is set as enabled. During
enabled status, PE, FAULT are output and printing
continues. During disabled status, nothing is output and
printing continues.
437,
KATAKANA,