Filter
Top Products
32
Chapter3
Preparing the Printer
7. Being careful not to let the copy roll
paper set on the rewinder shaft
slacken, place the roll paper in the
grooves on both sides.
Turn the flange on the rewinder shaft
in the direction shown by the arrow
and make sure that the copy roll
paper rotates with the rewinder shaft.
8.With the other side of the copy roll
paper (original side) pulled lightly
taut, close the rear cover firmly until
you hear a click.
Hold the center of the roll paper to pull
it as straight as possible so that one of
the sides of the paper does not slacken.
Paper feeds automatically and stops
at the print start position.
9.Tear off surplus paper by holding one
side of the end of the roll paper and
pulling it towards you.
Taking up slack while checking that
the copy roll paper winds.
Rear cover
Roll paper that is
gently pulled taut.
Installing roll paper
Do not insert any foreign
objects such as a paper clip
into the cutter unit.
Caution
Be very careful not to let
the rear cover catch your
hands when closing the rear
cover.
Caution