Filter
Top Products
– 38 –
FF
[Function] Prints and Ejects Single Sheet, and Prints and Returns in Paper Mode
[Code] ASCII FF
Hexadecimal 0C
Decimal 12
There is the following difference between the standard mode and page mode:
<Standard Mode>
[Outline] This command prints the data in the print buffer and ejects a single sheet.
[Caution] • If a single sheet ejection length by ESC C has not been set, the paper will be ejected
completely. If it has been set, the paper will be ejected by a set amount. If the no-paper
condition is detected halfway ejection, the printer will stop paper ejection even before
reaching the set ejection amount.
• The single sheet ejecting direction is specified by ESC F.
[See Also] ESC F, ESC C
<Page Mode>
[Outline] Prints in batch the data developed across the print area and returns to the standard mode.
When this is done, all the developed data are erased after printing. The paper is not ejected.
[Caution] • The head of the line is assumed to be the next printing position.
[See Also] ESC L