Filter
Top Products
– 68 –
ESC v
[Function] Sends Paper Sensor Status
[Code] ASCII ESC v
Hexadecimal 1B 76
Decimal 27 118
[Outline] This command sends the status of the paper sensor when it is executed.
[Caution] The following table describes the status sent.
• If DTR/DSR control is selected and the memory switch 4-5 is set to 0, the printer sends only
1 byte after confirming that the host is ready to receive (the DSR signal status is Space).
If the host is not ready (the DSR signal status is Mark), the printer will wait until it will be
ready to receive. If XON/XOFF control is selected or the memory switch 4-5 is set to 1, the
printer will send only 1 byte without confirming the DSR signal status.
• If printing is under way, the printer will sends the then status after printing that line and
feeding the paper (the status sending timing differs from ESC u and GS I).
• Since this command is executed at deployment of the reception buffer, there may be a delay
between command reception and status sending, depending on the reception buffer
condition.
• If ASB is enabled by GS a, it is necessary to distinguish the status by this command from that
of ASB. See “6. Interface” for how to distinguish them.
[See Also] DLE EOT, GS a, 2.3 Paper Specifications and Print Area, 6. Interface
Bit Description Hexadecimal Decimal
0 BOF sensor with paper 00 0
BOF sensor without paper 01 1
1 TOF sensor with paper 00 0
TOF sensor without paper 02 2
2 Undefined – –
3 Undefined – –
4 Unused 00 0
5 Undefined – –
6 Undefined – –
7 Unused 00 0