Citizen Systems PD-22 Printer User Manual


 
8
7 Precautions to be followed when handling the printer
Warning
If the printer is used after it has become hot or produced smoke, a strange smell,
etc., it will start a fire. Immediately cut off the power, remove its battery, and
contact your service representative.
If any foreign matter (metal scraps, water, or other fluid) gets inside the printer,
first cut off the power and remove the battery, then contact your service represen-
tative. If you use it in this condition, it will start a fire.
Precaution
Do not put in on top of a shaky stand or other unstable place. If may fall or topple
over causing an injury.
Neither uses it nor stores it in the following locations. If you do, it will malfunction.
In a car that is exposed to the sun, in any place exposed to direct sunlight, near
a heater etc.
Place where the temperature and humidity are very high or low or where they
fluctuate widely.
Extremely dusty place
Place exposed to water or other fluid
Do not drop it or vigorously strike or vibrate it. If you do, it will be damaged or
malfunction.
Keep all foreign material out of the printer. This will cause it to malfunction.
Do not use a volatile fluid (thinner, benzine, etc.) or wet cloth to clean the printer.
If you do, it will be degraded or discolored. Clean it with a dry soft cloth.
During printing or when it is in standby status, do not move, shake or strike the
printer. There is a danger that the power will be cut off, losing printing data.