Filter
Top Products
PROGRAMMING
!RFID LEDFLSH
Function Controls the transmission of a ‘Success’ or ‘Failure’
indication to the LED display during and at the
very end of any CPL-RFID command’s execution.
Explicit Form
!RFID LEDFLSH ON/OFF/ACCUM
Parameters
ON
Flashes LED (Green for Success) or (Red
for Failure) after any CPL-RFID
command completion
OFF
Does NOT flash any LED after CPL-
RFID command completions. The LED
normally remains OFF during a label-
format execution until the printer is
ready for the next label or command
where LED is set Green
ACCUM
Does NOT flash any LED until after the
entire label- format has completed
execution. If all CPL- RFID commands
completed successfully, the LED is
flashed GREEN and OFF three times.
If any CPL-RFID command failed, the
LED is flashed RED and OFF three
times.
Response No specific response
Command Type RFID Setup/Debug Command
Example To Printer:
!RFID LEDFLSH OFF
NOTE: All CPL-RFID Configuration-Setup Commands
are processed outside the context of a standard CPL
Label-Format (i.e. CPL beginning with a header-line ‘! 0
100 nnn 1’ and ending with ‘END’). Attempts to use
CPL-RFID Configuration-Setup Commands within a
Label-Format result are ignored without indication.
Copyright © 2004, Cognitive. 55