Filter
Top Products
PROGRAMMING
!RFID TXAFTER
Function This command controls the state of the hardware’s
RF carrier transmission after any Host Command
to read, write or write and lock an RFID-Tag
Explicit Form
!RFID TXAFTER ON/OFF
Parameters
ON
Causes hardware to keep RF carrier
transmission ON after CPL-RFID Tag-
Interface command completion.
OFF
Causes hardware to turn RF carrier
transmission OFF after CPL-RFID Tag-
Interface command completion
Response No specific response
Command Type RFID Setup/Debug Command
Example To Printer:
!RFID TXAFTER OFF
!RFID ?
From Printer:
Setup/Config Parameters:
Assigned Tag Type: ISO15693
| | |
LED Flash Duration: 250 MSecs
SelecTag before Cmd: ON
TxPowerRF after Cmd: OFF
| | |
NOTE: All CPL-RFID Configuration-Setup Commands
are processed outside the context of a standard CPL
Label-Format (i.e. CPL beginning with a header-line ‘! 0
100 nnn 1’ and ending with ‘END’). Attempts to use
CPL-RFID Configuration-Setup Commands within a
Label-Format result are ignored without indication.
Copyright © 2004, Cognitive. 64