Compaq S0000 / 8000 Personal Computer User Manual


 
98 user’s guide
To release a hard disk drive from the chassis of the 8000 series, slide the
drive lock mechanism (1) to unlock the drive in the drive bay, remove the
metal drive shield (2) by pressing and lifting the two tabs on one side of the
shield, and then pull the drive out of the drive bay (3).
3
1
4
2
removing a hard disk drive from the 8000 series
5 For both the S0000 and 8000 series, if you are replacing the old drive with a
new drive, remove the four screws (4) (two on each side) from the old drive.
You need these screws to install the new drive.
NOTE: If you have the S0000 series, and you removed a 7-In-1 memory card
reader, continue to step 7; otherwise, you are finished with the task of
removing a drive from the chassis.
If you have the 8000 series and you removed a hard disk drive, a 7-In-1
memory card reader, or an optical drive, you are also finished with this
task. If you have the 8000 series and you removed a diskette drive, continue
to step 6.
6 For an 8000 series diskette drive, squeeze inward on both sides of the bracket
brace and lift the brace up and out (1). Remove the two sets of screws (2) (left
and right sides) that secure the drive to the drive adapter. Lift the diskette
drive out of the drive adapter (3) by sliding the drive back and then up.
Ensure that the guide screws (4) (left and right sides) are left in the drive
adapter. You are finished with the task of removing the drive.
2
2
3
1
2
4
removing a diskette drive from the drive adapter on the 8000 series