Filter
Top Products
GRYPHON™ D432/D432E
4
The field of view indicated by the aiming system will be smaller when the
Gryphon™ D432/D432E is closer to the code and larger when it is farther from the
code. Symbologies with smaller bars or elements (mil size) should be read closer to
the unit. Symbologies with larger bars or elements (mil size) should be read farther
from the unit. (See chapter 9 for further details).
3.2 NORMAL OPERATION
Gryphon™ D432/D432E normally functions by capturing and decoding codes.
Point the reader at the target and pull the trigger to enable the aiming system and the
illuminator (red beam) to capture and decode the image. The aiming system will
briefly switch off during the acquisition time and if no code is decoded will switch on
again before the next acquisition. The illuminator will remain on until the symbol is
decoded.
As you are reading code symbols, adjust the distance at which you are holding the
reader.
The Aiming System Delay parameter can be used to set a delay between the
activation of the aiming system and the activation of the illuminator. This allows more
time to center the reader over the target before image acquisition.
NOTE
The Gryphon™ D432/D432E hand-held reader aiming system is
designed for general reading and decoding of 1D and 2D symbols.
Some variation in reading distance will occur due to narrow bar width
and other factors.
NOTE
If reading codes positioned on reflective surfaces, it may be
necessary to tilt the reader with respect to the barcode and/or set the
Camera Control parameters (see page 50).
3.3 IMAGE CAPTURING
Gryphon™ D432/D432E can also function as a camera by capturing images of
labels, signatures, and other items.
In order to capture an image, the user should read a Capture Image code (see
page 73), then point at the image subject and pull th
e trigger. This way, the image
will be captured and sent to the host PC. Gryphon™ D432/D432E then returns to