Filter
Top Products
20 E-4203/E-4204/E-4304
9) CONTROL CODES
Allows code selection listed in
Programmer’s manual.
Possible Values:
* (STD) STANDARD CODES
(ALT) ALTERNATE CODES
10) CONT FORM LENGTH
This command sets the page size (label
length) when the printer’s ‘SENSOR
TYPE’ is set to continuous media.
Possible Values:
Range: 0 – 9999; default = *100
Units: .01 inch
11) OOS MAXVOLT
Sets the sensor reading that can
indicate OOS, (out of stock
condition).
Possible Values:
Range: 0 – 16; default = *2
Units: 0.1 volt
12) TOF GAIN
Sets Top of Form (TOF) Gain value.
Possible Values:
Range: 0 – 15; default = *10
13) TOF DELTA
Sets minimum change in the sensor
reading required to recognize a
“Gap” or Mark”.
Possible Values:
Range: 0 – 50; default = *10
Units: 0.1 volt
14) TOF LOW
Sets the minimum sensor reading for
paper (EDGE) or mark (Reflective).
Possible Values:
Range: 0 – 50; default = *0
Units: 0.1 volt
15) LABEL WIDTH
Sets the label width.
Possible Values:
Range: 75 – 410; default = *410
Units: .01 inch
16) Scalable Font
Sets the number of 4K Byte blocks
allocated for scaleable fonts.
Possible Values:
Range: 0 – 255; default = *64