Filter
Top Products
34 E-4203/E-4204/E-4304
4.7 Internal Labels
The following sections explain each of the printer’s internally generated
test and configuration labels.
4.7.1 Database Configuration and Dot Check Label
To print the Database Configuration and Dot Check Labels:
With the printer on, loaded with media (at least 4 inches wide), and
ribbon (if printing in thermal-transfer). Press the
+
buttons
simultaneously to print the Database Configuration and Dot Check Label
Alternately, press and hold the button and turning the printer on,
continue holding the F2 button until the PAUSED light turns off. Using
this method will initiate the ‘Character Dump Mode’. Turn the printer
off to terminate the ‘Character Dump Mode’.
The first label printed will be the Database Configuration Label, which
lists the printer's configuration and status.
FRI AUGUST 024, 2001 19:29 236
VER: ET4204 - 04.06 08/24/01
BOOT 83-2329-04A
CODE 83-2325-04F
FONT 83-2337-01A
CPLD 592157-01C
INTERNAL FLASH MODULE PRESENT
SYSTEM RAM CHECKS____ GOOD
SYSTEM RAM SIZE___ 2015 KBYTES
SYSTEM RAM AVAIL__ 1244 KBYTES
REG POWER SUPPLY__ YES
INPUT VALUES
PAPER_____________ 255
DARKNESS__________ 131
TRAN______________ 255
REFL______________ 149
RIBN______________ 87
TEMP______________ 48
VOLT______________ 223
CONFIGURATION
DIRECT THERMAL
SERIAL PORT SELECTED
19.2; 8BITS
EDGE
CONT FORM LENGTH__ 0
PRESENT ADJUST____ 127
SOP ADJUST________ 127
TOF LOW___________ 0 0
TOF DELTA_________ 10 10
TOF GAIN__________ 12 10
OOS MAXVOLT_______ 3 3
LABEL ALIGNMENT___ NO
ALIGN LENGTH______ 100
STOP LOCATION_____ HOST
COUNTER INFORMATION
ABSOLUTE VALUES 6-18-2001
LENGTH____ 773 INCHES
TIME______ 20 HOURS
RESETTABLE VALUES 6-22-2001
LENGTH____ 576 INCHES
TIME______ 10 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE______ 15
SCALABLE FONTS_______ 32
LABEL SIZE 0416:02157 IN