Filter
Top Products
48 E-4203/E-4204/E-4304
Skips every other label
(Print quality is good but skips every other label).
• The label is formatted too close to the top edge of the form.
Leave white space equal to 8-dot rows at the top of the
label, approximately .02" (.5mm).
• The media is not calibrated, (see Chapter 4)
• The media sensor or media sensor circuitry may be
defective, call for service.
Unable to print in rotation 4
• The characters are formatted outside the dimensions of the
label. Check that the row/column values provide enough
room for the height of the characters or bar code to be
printed.
Prints light on the right side of the label
• The media width adjustment thumbwheel is set for a
narrower media width than the actual media being used,
(see Chapter 5).
• The printhead is not properly aligned, call for service.
• The printhead is not locked down.
Printer fails to turn on
• A fuse may be blown, call for service.
• Faulty AC cord, replace
• A bad power switch may exist on the printer, call for
service.
• A faulty AC wall outlet.