Filter
Top Products
support.dell.com Rack Installation Guide 1-9
10. Install a 12-24 x 0.75-inch truss-head Phillips screw through the top cover’s
mounting flange and the front panel spacer and into the front of the rack (see Fig-
ure 1-6).
11. Repeat steps 9 and 10 to secure the system to the left side to the rack.
12. Finish tightening the screws you installed in step 4.
Figure 1-6. Installing the Front Panel Spacers
13. Slide the system chassis into the top cover (which is now secured to the rack)
and secure the system using the captive thumbscrews on the front panel.
14. Attach the front bezel to the system (see the Installation and Troubleshooting
Guide for instructions).
This completes the two-post flush-mount rack installation.
12-24 x 0.75 inch
truss-head Phillips screw
(1 per mounting flange)
front-panel spacer
top cover’s
mounting flange