Filter
Top Products
Back to Contents Page
Display
DellStudio™1745/1747ServiceManual
Display Assembly
Display Bezel
Display Panel
Display Panel Cable
Display Assembly
Removing the Display Assembly
1. Follow the procedures in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the base cover (see Removing the Base Cover).
4. Disconnect the antenna cables from the Mini-Card(s) (see Removing the Mini-Card).
5. Disconnect the subwoofer assembly cable from the subwoofer assembly cable connector on the system board (see Removing the Palm Rest).
6. Remove the two screws from the computer base.
7. Remove the center control cover (see Removing the Center Control Cover).
8. Remove the keyboard (see Removing the Keyboard).
9. Remove the media controls board (see Removing the Media Controls Board).
10. Remove the screw that secures the display cable to the computer base.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
antenna cables
2
subwoofer assembly cable