Back to Contents Page
Hard Drive(s)
DellStudio™1745/1747ServiceManual
Removing the Hard Drive(s)
Replacing the Hard Drive(s)
Removing the Hard Drive(s)
1. Follow the procedures in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the base cover (see Removing the Base Cover).
4. Remove the hard drive(s) from the computer base.
l For hard drive 1:
¡ Remove the four screws that secure the hard drive assembly to the computer base.
¡ Using the pull-tab, slide the hard drive towards the left to disconnect the hard drive assembly from the connector on the system board.
¡ Lift the hard drive assembly out of the computer base.
¡ Remove the four screws that secure the hard drive cage to the hard drive.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To prevent data loss, turn off your computer (see Turning Off Your Computer) before removing the hard drive. Do not remove the hard
drive while the computer is On or in Sleep state.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: Hard drives are extremely fragile. Exercise care when handling the hard drive.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
NOTE: If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard
drive (see the Dell Technology Guide).
CAUTION: When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge"
in the safety instructions that shipped with your computer).
1
pull-tab
2
hard drive assembly
3
screws (4)