Filter
Top Products
11. Disconnect the display cable, camera cable, and power button cable from the respective system board connectors.
12. Make note of the antenna cable and subwoofer cable routing, and carefully dislodge the cables from the routing guides and release them through the
slot.
13. Make note of the display cable, power button cable, and camera cable routing and carefully dislodge the cables form their routing guides.
14. Remove the four screws (two on each side) that secure the display assembly to the computer base.
15. Lift and remove the display assembly from the computer base.
Replacing the Display Assembly
1. Follow the procedures in Before You Begin.
2. Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.
3. Route the antenna cables and subwoofer cable through the slot and routing guides.
4. Route the display cable, power button cable, and camera cable through their routing guides.
1
display assembly
2
screws (4)
3
power button cable connector
4
camera cable connector
5
display cable connector