Filter
Top Products
Back to Contents Page
Base Cover
DellStudio™1745/1747ServiceManual
Removing the Base Cover
Replacing the Base Cover
Removing the Base Cover
1. Follow the procedures in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the six screws that secure the base cover to the computer base.
4. Lift the base cover off the computer at an angle as shown in the following illustration.
Replacing the Base Cover
1. Follow the procedures in Before You Begin.
2. Align the four tabs on the base cover with the slots on the computer base and gently snap it into place.
3. Replace the six screws that secure the base cover to the computer base.
4. Replace the battery (see Replacing the Battery).
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
screws (6)
2
base cover
3
tabs (4)