Filter
Top Products
Installing System Components 69
Figure 3-11. Removing and Installing the Fan Bracket
Replacing the Fan Bracket
1
Insert the two tabs on the right side of the fan bracket into the two slots on the system board tray.
2
Gently rotate the left end of the fan bracket downward into the system until the release latch and
plastic clip fully engage.
3
Reinstall the SAS controller daughter card. See "Installing a SAS Controller Daughter Card" on
page 70.
4
Replace the fans in the fan bracket. See "Replacing a Cooling Fan" on page 66.
5
Close the system. See "Closing the System" on page 55.
6
Reconnect the system to the electrical outlet and turn on the system and attached peripherals.
SAS Controller Daughter Card
Your system includes a dedicated slot on the sideplane for a SAS controller daughter card. The SAS
controller daughter card provides the SAS storage subsystem for your system’s internal hard drives. The
optional SAS RAID controller daughter card allows you to set up any internal hard drives in a RAID
1 release latch 2 fan bracket 3 plastic clip
4 fan bracket slot in power
supply cage
5tabs (2)
1
5
3
2
4
Book.book Page 69 Friday, February 3, 2006 11:09 AM