Dell 2950 Server User Manual


 
Installing System Components 95
Figure 3-29. Installing and Removing a Processor
13
Lift the processor out of the socket and leave the release lever up so that the socket is ready for the new
processor.
NOTICE: Be careful not to bend any of the pins on the ZIF socket when removing the processor. Bending the pins
can permanently damage the system board.
Installing a Processor
1
Unpack the new processor.
2 Align the
p
rocessor with the
socket keys on t
he ZIF socket. See
Figure 3-29.
3
I
nstall the processor in the socket.
NOTICE: Positioning the processor incorrectly can permanently damage the system board or the processor when
you turn it on. When placing the processor in the socket, be careful not to bend the pins in the socket.
a
If the release lever on the processor socket is not positioned all the way up, move it to that
position.
b With the
p
rocessor and
the
socket
keys
aligned, set the processor lightly in the socket.
NOTICE: Do not use force to seat the processor. When the processor is positioned correctly, it engages easily into
the socket.
c
Close the processor shield. See Figure 3-29.
d
W
hen the processor is fully seated in the socket, rotate the socket release lever back down until
it snaps into place, securing the processor.
See Figure 3-29.
1 notch in processor (2) 2 processor 3 socket-release lever
4 processor shield 5 ZIF socket 6 socket key (2)
3
6
4
5
1
2
Book.book Page 95 Friday, February 3, 2006 11:09 AM