Filter
Top Products
20 About Your System
• Eleven LEDs (two iSCSI In link speed/activity, two iSCSI In link duplex
mode, two Ethernet link/speed, battery fault, SAS link fault/connectivity,
cache active, controller fault, and controller power)
• One SAS Out port connector
• Debug port
For a description of each component on the front panel of the RAID
controller module, see Table 1-4. For an explanation of how to connect the
enclosure using the
RAID controller module
ports, see the
PowerVault
MD3000i Installation Guide
.
Figure 1-5. RAID Controller Module External Panel (front view)
Table 1-4. RAID Controller Module Component Functions
Item Component Icon Function
1 iSCSI In Port 0 Link
Speed/Activity
Status LED
Green: Link is operating at 1000 Mbps.
Amber: Link is operating at 100 Mbps.
Off: iSCSI connection is not active.
2 iSCSI In Port 0 In-0 Provide host-to-controller iSCSI
connection. If LED is solid, there is no
activity on the link. If the LED is blinking,
there is activity on the link.
3 iSCSI In Port 0 Link
Duplex Mode
Green: Full-duplex mode.
Off: Half-duplex mode.
NOTE: Half-duplex mode is supported only if
the link speed is 100Mbps.
1 68 9 10 11 13 15 1612 1442 3 5 7