Filter
Top Products
60 Installing Enclosure Components
4
Rotate the carrier handle to the closed position while continuing to push
the carrier into the slot.
The status LED indicator (see Table 1-3 for description) will display a
steady green if the
physical disk
is inserted properly. If the indicator is not
illuminated, see "Troubleshooting SAS Physical Disks" on page 76.
NOTE: At least two physical disks must be installed in the enclosure.
Removing and Installing a RAID Controller
Module
The enclosure contains two RAID controller modules. Both are hot-pluggable
and can be removed and installed independently without shutting down the
enclosure.
NOTICE: Removing a module is not recommended while data traffic involving that
module is occurring. Although RAID controller modules are hot-pluggable, data loss
could result from removing a module involved in data traffic.
CAUTION: Always wear a wrist grounding strap when handling equipment with
static-sensitive components. See your Product Information Guide for safety
information.
Removing a RAID Controller Module
1
Push up on the release tab on the left side of the module (see Figure 3-4).
2
At the same time, pull out on the release lever. When the lever is pulled
out, the controller module partially ejects from the
enclosure
.
3
Remove the module from the
enclosure
and place it on a flat, secure
surface.
NOTICE: To avoid damage to the sensitive EMI contacts on the bottom of the
controller module, do not stack or place it on a hard surface.