Filter
Top Products
Figure 27. Removing the System Battery Cover
1. system battery cover
2. network daughter card cooling shroud
3. touch points
4. Locate the battery socket.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
5. To remove the battery, press down firmly on the positive side of the connector and lift the battery out of the
securing tabs at the negative side of the connector.
Figure 28. Replacing the System Battery
1. positive side of battery connector
2. system battery
3. negative side of battery connector
6. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs at the
positive side of the connector.
7. Press the battery straight down into the connector until it snaps into place.
8. Align the back of the system battery cover with the notch on the network daughter card cooling shroud and push
the system battery cover down into the notches till it snaps into place.
58