Filter
Top Products
44 | Removing and Replacing Parts
www.dell.com | support.dell.com
Figure 10-1. Fan Tray
Removing and Replacing Power Modules
The E600i supports a minimum of one DC PEM or three 100 VAC Power Supplies (two for 200 VAC).
You must have one type of power module in the chassis; you cannot install a mixture of power supply
modules (see
AC Power Supply Units on page 22
). Blanks must be installed in any empty power supply
slot.
Replacing 2500W AC Power Supply
The E600i 2500W AC Power Supply (CAT# CC-E600-2500W-AC2) is capable of operating at either 110
VAC or 220 VAC.
CAUTION: Before removing and replacing a power supply module, determine if the E600i is in power supply
redundancy or non-redundant power. Operating in non-redundant power will require a complete system power
off when removing or replacing a power supply.
FN0076A