Filter
Top Products
The sled is powered off when all the nodes are turned off.
2. Remove the sled from the enclosure.
3. Install an I/O connector cover on the I/O connector(s) at the back of the board.
WARNING: The processor and heat sink can become extremely hot. Be sure the processor has had sufficient
time to cool before handling.
WARNING: The memory modules are hot to the touch for some time after the system has been powered
down. Allow time for the memory modules to cool before handling them. Handle the memory modules by the
card edges and avoid touching the components.
NOTE: If you are removing more than one hard drive/SSD, label them so you can replace them in their original
locations.
4. Remove the following:
a. hard drives/SSDs
b. hard-drive/SSD backplane
c. memory modules
d. cable cover
e. cooling shroud
f. Easy Restore Module
CAUTION: Do not lift the system board assembly by holding a memory module, processor, or other
components.
5. Disconnect all cables from the system board.
6. Remove the screws securing the system board to the chassis.
7. Holding it by the edges, lift the system board out of the chassis.
8. Ensure that the I/O connector cover is still in place on the I/O connector at the back of the board.
51