Filter
Top Products
Figure 28. Removing and installing the control panel
1. control-panel bracket 2. control-panel cable connector
3. control-panel board 4. sled
5. screws (2)
Installing the control panel
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. Align the screw holes on the control-panel board with the screw holes on the control-panel bracket.
2. Install the three screws to secure the control-panel board to the control-panel bracket.
3. Connect the control-panel cable to the connector on the control-panel board.
4. Position the control-panel assembly so that the USB connector and USB select button face the front of the system.
5. Slide the control-panel assembly into the chassis, until the USB select button and connector align with the slots on
the chassis.
The screw holes on the control-panel bracket align with the screw holes on the chassis.
6. Install the two screws to secure the control-panel assembly to the chassis.
7. Install the following:
a. system board
b. hard-drive/SSD backplane
c. cooling shroud
54