Filter
Top Products
Item Connector Description
16 D CPU and heat sink for Node D
17 D_A1, D_A2 Memory module sockets for node D
18 J_BP_PWR Hard-drive/SSD backplane power connector
19 J_CP Control panel connector
Disabling a forgotten password
The sled software security features include a system password and a setup password. The password jumper enables
these password features or disables them, and clears any password(s) currently in use.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. Turn off the nodes using the operating system commands, or the iDRAC, or the CMC.
The sled is powered off when all the nodes are turned off.
2. Remove the sled from the enclosure.
3. Locate the jumpers on the system board.
4. Relocate the jumper plug to disable the password feature.
5. Install the sled in the enclosure.
6. Turn on the sled.
When the sled is on, the power-on indicator is solid green. The nodes also power on when the sled is turned on,
and the node indicators are solid blue. Allow the sled to finish booting.
The existing passwords are not disabled (erased) until the system boots with the password removed. However,
before you assign a new system and/or setup password, you must reinstall the password jumper.
NOTE: If you assign a new system and/or setup password with the jumper removed, the system disables the
new password(s) the next time it boots.
7. Turn off the nodes using the operating system commands, or the iDRAC, or the CMC.
The sled is powered off when all the nodes are turned off.
8. Remove the sled from the enclosure.
9. Locate the jumpers on the system board.
10. Relocate the jumper plug to enable the password feature.
11. Install the sled in the enclosure.
12. Turn on the sled.
13. Assign a new system and/or setup password.
64