Filter
Top Products
Back to Contents Page
Antenna
Dell™OptiPlex™FX160/160ServiceManual
Removing the Antenna
Replacing the Antenna
Removing the Antenna
1. Perform the procedure in Before Working on Your Computer.
2. Remove the hard drive bracket assembly, if installed (see Removing the Hard Drive Bracket Assembly).
3. Remove the WLAN card (see Removing the Wireless Card).
4. Remove the antenna cable from under the metal tab on the back panel.
5. On the inside of the chassis, squeeze the bushings together and at the same time, carefully pull the antenna out the back of the computer.
Replacing the Antenna
1. Remove the plug, if installed, from the opening for the antenna in the back panel.
2. If missing, install an antenna holder in the opening for the antenna in the back panel.
3. Route the antenna wires through the antenna holder on the back of the chassis.
4. Align the antenna bushing with the antenna holder of the back panel so that when you flip up the antenna, it will be above the computer (when the
computer is in vertical orientation).
5. Push the antenna bushing tabs through the antenna holder until the tabs snap into place.
WARNING: Ensure that the antenna wires are in the center of the antenna bushing before pressing the bushing tabs together. If the wires are
pushed to the side, they may become damaged when the bushing tabs are pressed.
1
wireless antenna
2
antenna holder
3
antenna bushing tabs (2)
4
metal tab over wire mesh