Filter
Top Products
2-2
'HOO,QVSLURQ6HUYLFH0DQXDO
9LVXDO,QVSHFWLRQ
&$87,21%HIRUH\RXSURFHHGZLWKWKHYLVXDOLQVSHFWLRQHQVXUHWKDW
WKHXVHUKDVVDYHGDOORSHQILOHVDQGH[LWHGDOORSHQDSSOLFDWLRQSUR
JUDPVLISRVVLEOH
The visual inspection consists of a quick inspection of the exterior of the com-
puter and any attached peripherals, including making any necessary
corrections. For information about the proper removal and installation of com-
puter components, as instructed in the following procedure, see Chapter 4,
“Removing and Replacing Parts.”
To perform a visual inspection, follow these steps:
1. Determine the power state of the computer.
If the system is on
, go to step 2.
If you are unsure whether the system is on
, shut down and restart the sys-
tem, and then go to step 2.
2. Turn off any attached peripherals, and then shut down the computer.
3. Verify that the exterior of the computer is free of any obvious physical
damage.
4. If the computer is operating from an AC adapter, verify the following:
a. The AC adapter’s AC power cable is connected to both the AC adapter
and the electrical outlet. The AC adapter’s indicator light should be on.
b. The AC adapter’s DC power cable is properly connected to the com-
puter’s AC adapter connector.
c. The AC adapter and cables are free of any obvious physical damage.
5. If the computer is operating from battery power, remove any installed bat-
teries, verify that they are free of any obvious physical damage, verify that
the connectors on the battery and inside the battery bay are not damaged,
and then reinsert the batteries into their respective compartments. Press
the test button located on the back of each battery to make certain that
there is a charge.
6. Remove the combo module (CD-ROM/diskette drive or DVD-ROM/diskette
drive) if installed, verify that it is free of any obvious physical damage, verify
that the connectors on the combo module and inside the options bay are
not damaged, and then reinsert the drive into the options bay.
7. Remove any installed PC Cards from the PC Card slot, verify that they are
free of any obvious physical damage, verify that the connectors on the PC
Cards and inside the PC Card cage are not damaged, and then reinsert the
card(s) into the PC Card slot.