Filter
Top Products
4-58
'HOO,QVSLURQ6HUYLFH0DQXDO
3URFHVVRU%RDUGDQG0HPRU\0RGXOH
This section provides the removal procedure for the processor board and
memory module. The processor board and memory module can be removed
without removing the palmrest assembly.
)LJXUH3URFHVVRU%RDUG DQG0HPRU\0RGXOH5HPRYDO
This procedure assumes that you have removed the heat exchanger/fan. To
remove the processor board and memory module, follow these steps (see
Figure 4-39):
1. Remove the three 5-mm screws securing the processor board to the sys-
tem board.
2. Gently pull the processor board off of connector JP15 on the system board.
Do not rock the board to remove it, because this may damage the
connectors.
3. Lift the SODIMM heat sink off of the memory module.
4. Remove the memory module.
Carefully spread the inner metal tabs of the memory module socket to dis-
engage the module from the socket. The module should pop up slightly.
Then pull the memory module out of the socket.
5-mm
screws (3)
processor board
memory module
SODIMM heat
sink