Filter
Top Products
4-46
'HOO,QVSLURQ6HUYLFH0DQXDO
3DOPUHVW$VVHPEO\
This section provides the removal procedure for the palmrest assembly.
)LJXUH 3DOPUH VW$VVHPEO\5HPRYDO
This procedure assumes that you have removed the keyboard, thermal shield,
and display assembly. To remove the palmrest assembly, follow these steps
(see Figure 4-30):
1. Turn the unit over and place it face down.
2. Remove the two 4-mm screws from the top inside of the combo bay.
3. Remove the two 4-mm screws from the top inside of the battery bay.
4. Remove the two 4-mm screws from the top inside of the hard-disk drive
bay.
palmrest
assembly
6-mm
screws (4)
base
assembly
4-mm
screws (6)
LED cable
speaker wire harness
and grounding strap
LED connector
connector
for speaker
wire
harness
DC-DC board
washer
4-mm screw
combo bay
hard-disk
drive bay
battery bay