Filter
Top Products
4-38
'HOO,QVSLURQ6HUYLFH0DQXDO
)URQW%H]HO
This section provides the removal procedure for the front bezel.
)LJXUH)URQW%H]HO5HPRYDO
This procedure assumes that you have removed the display assembly from the
computer base. To remove the front bezel, follow these steps (see
Figure 4-25):
1. Use a dental pick to pry the rubber screw covers off of the bottom two
screws and the rubber bumpers off of the top two screws.
2. Remove the four 6-mm screws from the front bezel.
3. Unsnap the front bezel from the back cover and remove it from the
assembly.
Carefully insert your fingers between the LCD panel and the bezel. Roll the
plastic up slightly to insert your fingers further in, and then lift upward to
free the snaps. Start at the middle bottom and then work around.
When replacing the bezel, ensure that the LCD wire harness is routed
correctly through the openings in the back cover and is not pinched.
6-mm screws (4)
rubber bumpers (2)
rubber screw covers (2)
front bezel