Filter
Top Products
10. Using your fingertips, gently ease the palm-rest assembly from the top cover.
11. Without pulling hard on the palm-rest assembly, turn the palm-rest assembly over and place it on the top cover.
12. Lift the connector latch and pull the pull-tab to disconnect the control-strip cable from the system-board connector.
13. Lift the connector latch and pull the pull-tab to disconnect the touch-pad cable from the system-board connector.
14. Lift the palm-rest assembly off the top cover.
Replacing the Palm-Rest Assembly
1. Follow the instructions in Before You Begin.
2. Slide the touch-pad cable into the system-board connector and press down on the connector latch to secure the cable.
3. Slide the control-strip cable into the system-board connector and press down on the connector latch to secure the cable.
4. Place the palm-rest assembly on the top cover and gently snap the palm-rest assembly into place.
5. Close the display and turn the computer over.
1
palm-rest assembly
2
top cover
3
tab
CAUTION: Carefully separate the palm-rest assembly from the top cover to avoid damage to the palm-rest assembly.
1
control-strip cable connector
2
touch-pad cable connector
3
top cover
4
palm-rest assembly