Filter
Top Products
Configuring Switching Information 441
Figure 7-106. Dynamic ARP Inspection Global Configuration
The Dynamic ARP Inspection Global Configuration page contains the following fields:
•
Validate Source MAC
— Select the DAI Source MAC Validation Mode for the switch. If you select
Enable, Sender MAC validation for the ARP packets will be enabled. The default is Disable.
•
Validate Destination MAC
—Select the DAI Destination MAC Validation Mode for the switch. If you
select Enable, Destination MAC validation for the ARP Response packets will be enabled. The default
is Disable.
•
Va lidat e IP
—Select the DAI IP Validation Mode for the switch. If you select Enable, IP Address
validation for the ARP packets will be enabled. The default is Disable.
Configuring Dynamic ARP Inspection Global Settings With CLI Commands
For information about the CLI commands that perform this function, refer to the following chapter in
the
CLI Reference Guide
:
• Dynamic ARP Inspection Commands
The following table summarizes the equivalent CLI commands for this feature.
DAI Interface Configuration
Use the DAI Interface Configuration page to select the DAI Interface for which information is to be
displayed or configured.
Table 7-58. Dynamic ARP Inspection Global Commands
CLI Command Description
ip arp inspection validate Enables additional validation checks like source MAC address
validation, destination MAC address validation or IP address validation
on the received ARP packets.
show ip arp inspection Displays the Dynamic ARP Inspection configuration on all the DAI
enabled interfaces.