Filter
Top Products
534 Configuring Routing
Configuration data for this interface display.
Configuring an OSPF Interface using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• OSPF Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 9-11. OSPF Interface Configuration Commands
CLI Command Description
ip ospf area Enables OSPFv2 and sets the area ID of an interface.
ip ospf authentication Sets the OSPF Authentication Type and Key for the specified
interface.
ip ospf cost Configures the cost on an OSPF interface.
ip ospf dead-interval Sets the OSPF dead interval for the specified interface.
ip ospf hello-interval Sets the OSPF hello interval for the specified interface.
ip ospf network Configure OSPF to treat an interface as a point-to-point rather than
broadcast interface.
ip ospf priority Sets the OSPF priority for the specified router interface.
ip ospf retransmit-interval Sets the OSPF retransmit Interval for the specified interface.
ip ospf transmit-delay Sets the OSPF Transit Delay for the specified interface.
network area Enables OSPFv2 on an interface and sets its area ID if the IP address of
an interface is covered by this network command.
passive-interface Sets the interface or tunnel as passive.
show ip ospf interface Displays the information for the IFO object or virtual interface tables.
show ip ospf interface brief Displays brief information for the IFO object or virtual interface
tables.