Filter
Top Products
About Your System 21
Caution!
NVRAM_CLR jumper
is installed on
system
board.Please run
SETUP.
NVRAM_CLR jumper is
installed in the clear
setting. CMOS has been
cleared.
Move the NVRAM_CLR
jumper to the default position
(pins 3 and 5). See Figure 6-1
for jumper location. Restart
the system and re-enter the
BIOS settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 35.
CPU set to
minimum
frequency.
The processor speed may
be intentionally set lower
for power conservation.
If not an intentional setting,
check other system messages
for possible causes.
Current boot mode
is set to UEFI.
Please ensure
compatible
bootable media is
available. Use
the system setup
program to change
the boot mode as
needed.
The system failed to boot
because UEFI boot mode is
enabled in BIOS and the
boot operating system is
non-UEFI.
Ensure that the boot mode is
set correctly and that the
proper bootable media is
available. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 35.
Decreasing
available
memory.
Faulty or improperly
installed memory modules.
Reseat the memory modules.
See "Troubleshooting System
Memory" on page 119.
Embedded NICx and
NICy:
OS NIC=<ENABLED
|DISABLED>,
Management
Shared NIC=
<ENABLED
|DISABLED>
The operating system NIC
interface is set in BIOS.
The Management Shared
NIC interface is set in
management tools.
Check the system
management software or the
System Setup program for
NIC settings. If a problem is
indicated, see
"Troubleshooting a NIC" on
page 113.
Message Causes Corrective Actions
Coaster_HOM.book Page 21 Monday, November 3, 2014 3:23 PM