Filter
Top Products
94 Installing System Components
CAUTION: Be careful not to bend any of the pins on the ZIF socket when removing
the processor. Bending the pins can permanently damage the system board.
12
Carefully, lift the processor out of the socket and leave the release lever up
so that the socket is ready for the new processor.
Installing a Processor
1
Unpack the new processor.
2 Align the
p
rocessor with the
socket keys on t
he ZIF socket. See
Figure 3-19.
CAUTION: Positioning the processor incorrectly can permanently damage the
system board or the processor. Be careful not to bend the pins in the socket.
3
With the release lever on the processor socket in the open position, a
lign
the
p
rocessor with
the
socket
keys
and set the processor lightly in the
socket.
CAUTION: Do not use force to seat the processor. When the processor is
positioned correctly, it engages easily into the socket.
4
Close the processor shield.
5
R
otate the socket release lever down until it snaps into place.
6
Using a clean lint-free cloth, remove the thermal grease from the heat sink.
7
Open the grease packet included with your processor kit and apply thermal
grease evenly to the top of the new processor.
8 Place the heat sink on the processor. See
Figure 3-19
.
9 Using a #2 Phillips screwdriver, tighten the heat-sink retention screws.
See
Figure 3-18
.
10
Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 80.
11
Replace the expansion-card stabilizer. See "Installing the Expansion-Card
Stabilizer" on page 78.
12
Close the system. See "Closing the System" on page 60.
13
Reconnect the system and peripherals to their power sources, and turn
them on.
Coaster_HOM.book Page 94 Monday, November 3, 2014 3:23 PM