Filter
Top Products
Installing System Components 73
Figure 3-10. Attaching a SAS Hard Drive to a SAS Controller Expansion Card
7
Close the system. See "Closing the System" on page 60.
8
Place the system upright on a flat, stable surface.
9
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
10
Enter the System Setup program and ensure that the hard drive’s
controller is enabled. See "Entering the System Setup Program" on
page 36.
11
Exit the System Setup program and reboot the system.
12
Partition and logically format the drive.
See the documentation that came with the drive for instructions on
installing any software required for drive operation.
1 SAS hard drive 2 power/data cable to hard drive
3 data cable to SAS controller card 4 SAS controller card
3
4
1
2
Coaster_HOM.book Page 73 Monday, November 3, 2014 3:23 PM