Filter
Top Products
2
ENGLISH
ENGLISH
2 CONNECTIONS
CONNECTIONS
1. Turn off the POWER switch.
2. Connect the RCA pin cords to the inputs on your mixer.
CH6 Fader jackCH4 Fader jack
DN-X900
DN-HC4500
3.5 mm stereo mini cord
Deck2
Fader jack
CH6 Input jackCH4 Input jackRCA Cord RCA Cord
Deck1 Output jack Deck2 Output jack
DN-D4000/
DN-D4500/
BU4500
DENON PC/MAC Upgrade
Application and ASIO Driver
Application included.
COUTION:
• Be sure to use the supplied control cord. Using another type of cable may result in damage.
• Be sure the power is off when connecting the control cord. Otherwise the units may not work properly.
USB B terminal
CH2 Input jack
CH2 Fader jack
Drive1 Fader jack
Drive1 Output jack
Drive2 Fader jack
Drive2 Output jack
DRIVE terminal
CH8 Input jack
CH8 Fader jack
3.5 mm stereo mini cord
Deck1
Fader jack
Connection to a PC
RCA Cord RCA Cord
3.5 mm stereo
mini cord
3.5 mm stereo
mini cord
• The DN-HC4500 is a plug-and-play device.
This means that when the DN-HC4500 is first
connected to your computer, the driver is
installed automatically.
•To connect the DN-HC4500 and a PC via a usable
USB port, use the included USB cable.
• When connected, the display below appears at
the bottom right of the PC’s screen.
Once installation is completed, the message
“Your new hardware is installed and ready to
use.” is displayed, as shown below.
Installation is now complete. The DN-HC4500 is
now usable.
Connection to a Macintosh computer
• The DN-HC4500 is plug-and-play device based on
the Macintosh OS, and is immediately ready for
use when connected.
•To connect the DN-HC4500 and Macintosh
computer via a usable USB port, use the included
USB cable.
Computer OS versions that can be
connected to the DN-HC4500:
Windows XP SP2
Mac OSX 10.4 or later
Computers with other operating
systems are not compatible with USB
MIDI, so the computer may operate
erratically after connected to the DN-
HC4500 by USB.
Found New Hardware
USB audio device
Found New Hardware
Your new hardware is installed and ready to use.
Some features will not work for DN-D4000.
X-control