Filter
Top Products
AT Command Set and S-Registers
14-233910-A2-GN32-40 September 1998
Table 14-3
(9 of 13)
391x Series S-Registers
S-Register
DCP LCD
Command
Sequence
Description
S72 RTS Antistreaming. Register determines the antistreaming operation
of the modem.
Register has the following values:
0 = Disable
1 = 10 sec
2 = 30 sec
3 = 1 min
4 = 2 min
5 = 3 min
6 = 5 min
The factory setting is Disable.
Configure\Edit\
DTE Interface
S74 Network Position Identification. Register identifies each modem as
either a control or tributary modem.
Register has the following values:
0 = Tributary
1 = Control
The factory setting is Tributary.
Configure\Edit\
Misc
S75 Network Management Address. Register determines the modem’s
network address. This address is used when accessing the modem
from the 6700 Series NMS.
Enter a value from 0 (network address 001) to 255 (network address
256). The factory setting is 0.
Configure\Edit\
Dial
S76 V.32bis Autorate (Dial Line). Register determines if Autorating is used
on dial lines when connected in V.32bis mode.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
Configure\Edit\
Dial Line
S78 V.32bis Automode (Dial Line). Register allows the modem (when
operating on dial lines) to automatically detect and connect to the
remote modem’s modulation scheme.
Register has the following values:
0 = Enable
1 = Disable
The factory setting is Enable.
Configure\Edit\
Dial Line