Filter
Top Products
Modem Installation
2-73910-A2-GN32-40 September 1998
6. Press the key until the appropriate configuration area appears on the LCD, then press
the corresponding function key to select your choice. (Saving configuration options to the
Active (Saved) configuration area automatically saves them to the Active (Operating)
configuration area.) The LCD displays Command Complete.
7. The modem is now configured with the selected factory template. Press the
key to
return to the Top-Level menu.
Refer to Chapter 5, DCP Configuration, for more information regarding default factory
configuration options.
Using AT Commands
When using AT commands, the following criteria must be met:
• Make sure the asynchronous DTE’s communication software is configured for 10-bit
character format (for example, 8 data bits, no parity, and 1 stop bit).
• Make sure the DTE cable is attached to the DTE connector on the rear of the 391x Series
modem and to the correct serial communications port on the asynchronous DTE.
• Configure the modem for Async Dial, Async Leased, or UNIX Dial as described earlier in
Using the DCP. To verify that the modem is connected and functioning properly, enter the
following:
TYPE: AT
PRESS: Return (Enter)
The screen displays OK.
If the modem does not return OK, refer to Appendix B, Troubleshooting.
NOTE
If the factory preset configuration is something other than Async
Dial, Async Leased, or UNIX Dial, you do not have AT command
control. To regain AT command control, select, via the DCP, the
Async Dial factory preset configuration as described in Using the
DCP on page 2-6.