Filter
Top Products
COMSPHERE 3900 Series Modems
4-4 September 1998 3910-A2-GN32-40
Table 4-1
(2 of 2)
Health and Status Messages
Type IndicatesMessage
Dial Make Busy Mode The modem is in a Make Busy condition.
Service Line (Model 3911 only) The modem installed in a COMSPHERE 3000
Series Carrier has been switched to a service line.
Short Hold Time The modem’s dial hold time has been shortened.
Non-Answering The modem is in a non-answering mode.
Thresh* RSL High
Threshd
The received signal level (RSL) has exceeded the upper threshold.
RSL Low
Threshld
The RSL is less than the lower threshold.
SNR Threshold The signal-to-noise ratio has exceeded the threshold.
Non-linear Dist The non-linear distortion has exceeded the threshold.
Retrains The number of retrains has exceeded the threshold.
Signal Quality The signal quality is less than the threshold.
Far Echo Threshd The far end echo level has exceeded the threshold.
Near Echo Thresh The near end echo level has exceeded the threshold.
Security
Database Reset The security database has been reset (passwords erased).
y
Password Protect Security password protection has been enabled.
Mode Change There has been a change in security mode. (Refer to Chapter 12, Dial
Access Security.)
Password
Change
A security password has been changed.
Database Change The security database containing passwords has been changed.
Port 1 Rx Data Alarm The DTE port’s RXD signal is in an alarm condition.
Tx Data Alarm The DTE port’s TXD signal is in an alarm condition.
DTR Alarm The DTE port’s DTR signal is in an alarm condition.
CTS Alarm The DTE port’s CTS signal is in an alarm condition.
RTS Alarm The DTE port’s RTS signal is in an alarm condition.
DSR Alarm The DTE port’s DSR signal is in an alarm condition.
LSD Alarm The DTE port’s LSD signal is in an alarm condition.
Auto Stream Dis The modem is in an Antistreaming condition. (Refer to the Streaming
DTE message in the Major Alarm section of this table.)
Disabled The modem’s DTE port has been disabled.
*Not supported in every modulation.
To exit DeviceHS and remain in the Status Branch, press the key. To exit and return to the
Top-Level menu, press the key.