Filter
Top Products
22
you by your ISP. Dynamic IP requires no input here.
Gateway The IP address of the gateway device, as stated to you by your
ISP. Dynamic IP requires no input here.
Server IP The IP address of your ISP’s server computer, as stated to you
by your ISP.
L2PT Account The account name of the L2PT account that has been assigned
to you by your ISP.
L2PT Password The password of the L2PT account that was supplied to you by
your ISP.
L2PT Retype Password Retype the password that was entered in the L2PT field.
Ensure that these two passwords are identical or an error will
occur.
Maximum Idle Time A value of 0 means the PPP connection will remain connected.
If your network account is billed according to the amount of time
the Router is actually connected to the Internet, enter an
appropriate Idle Time value (in seconds). This will disconnect
the Router after the WAN connection has been idle for the
amount of time specified. The default value = 5.
MTU Enter an MTU value only if required by your ISP. Otherwise,
leave it at the default setting.
Connect Mode If Connect-on-demand is selected, will allow the router to
connect any workstation on your LAN to the Internet upon
request. If Always-on, no request from the workstation will be
needed to connect to the Internet. If Manual is selected, the
workstation on the LAN must manually connect to the Internet
through this router.
Home > WAN > Others > BigPond Cable
This selection is for users having Big Pond Cable as their ISP. Enter the following
information, as provided to you by your ISP.