Filter
Top Products
Section 3 - Configuration
OUTBOUND FILTER
By default, all outgoing IP traffic from the LAN is not restricted. The Outbound Filter allows you to create a filter rule to block outgoing IP traffic by
specifying a filter name and at least one condition below. All of the specified conditions in this filter rule must be satisfied for the rule to take effect.
To access the OUTBOUND FILTER settings window, click on the OUTBOUND FILTER button in the ADVANCED tab
ADD OUTBOUND IP FILTER
To create the new policy and fill in the filter name.
Choose ICMP, TCP/UDP, TCP or UDP on the Protocol.
Type Source IP address, Source Subnet Mask and Source Port (can
be single port or port range in “start port::end port” syntax )
Type Destination IP address, Destination Subnet Mask and
Destination Port (can be single port or port range in “start port::end port”
syntax )
Set the policy schedule on the Schedule, Always or never, or View
Available Schedules
Please click Add/Apply button to add the policy in the list.
D-Link DSL-3580L Series User Manual 68