Filter
Top Products
DSL-G804V Wireless ADSL Router User’s Guide
Parameter Description
Remote ID
Type
Specify Remote ID type.
Content
Input remote ID’s information, either email or domain name.
SA Lifetime
Phase 1 (IKE)
To issue an initial connection request for a new VPN tunnel. The range can be
from 5 to 15,000 minutes.
Phase 2 (IPSec)
To negotiate and establish secure authentication. The range can be from 5 to
15,000 minutes.
Note
A short SA time increases security by forcing the two parties to update the keys.
However, every time the VPN tunnel re-negotiates, access through the tunnel will be
temporarily disconnected.
PING for keepalive
It is used to detect IPSec tunnel connection failure. Connection failure is
defined as abort or in NO response state. In such event Ping to Keepalive
takes proper action to ensure the connection quality of IPSec.
PING to the IP
It is able to IP Ping the remote PC with the specified IP address and alert
when the connection fails. Once alter message is received, Router will drop
this tunnel connection. Re-establish of this connection is required. 0.0.0.0
which disables the function.
Interval
This sets the time interval between Pings to the IP function to monitor the
connection status. Time interval can be set from 0 to 3600 second, 0 second
disables the function.
Disconnection Time
after no traffic
It is the NO Response time clock. When no traffic stage time is beyond the
Disconnection time set, Router will automatically halt the tunnel connection
and re-establish it base on the Reconnection Time set. 180 seconds is
minimum time interval for this function.
Reconnection Time
It is the reconnecting time interval after NO TRAFFIC is initiated. Default
setting is 15 minutes; 3 minutes is minimum time interval for this function.
Ping to the IP Internal (sec) Ping to the IP Action
0.0.0.0 0 No
0.0.0.0 2000 No
xxx.xxx.xxx.xxx (A valid IP
Address)
0 No
xxx.xxx.xxx.xxx(A valid IP
Address)
2000 Yes, activate it in every
2000 second.
54