Filter
Top Products
6
2.0 Quick Startup
1
Your Powerware 9120 UPS has a removable power cord. Connect the power cord to the
back of the unit and plug the UPS into a wall outlet. The LCD backlight will illuminate and the
fan will run, but no output power is available.
2
Let the unit charge the battery for at least 3 hours. You may use the unit while the battery
charges, but the battery backup runtime will be reduced until the battery is fully charged.
3
Start the Powerware 9120 by pressing and holding the On/Standby button (large button in the
center of the front panel) in for about one second. Note: To turn the unit on, the On/Standby
button must be pressed for about one second and for about 5 seconds to turn the unit off.
3.a. When it starts, the unit beeps once, then twice, and lights the “Power On” LED. The unit
indicates “On Delay” on the LCD and performs an internal system and battery test. Next,
the Powerware 9120 applies AC output to the back panel receptacles and indicates “On
Line” on the LCD.
3.b. After 10 seconds or less, the self test is complete. The green LED will come on and
remain on. If the unit beeps, or if the green LED does not remain on even though input
power is available from the wall outlet, go to the Troubleshooting section.
4
Switch off the equipment you want to protect, and plug each load into the outlets on the back
of the Powerware 9120. Refer to Section 5.3 for detail on the load segment feature.
5
Switch on the protected equipment, one load at a time. If the UPS beeps an alarm when you
start your equipment, the UPS may be overloaded. See the Troubleshooting section.
The LCD on the front of the UPS shows the % of load capacity that your equipment is using.
See Section 3.0 Operation for more information on checking the load %.
.
6
The RJ-45 Surge Protection jacks will protect equipment that uses an
RJ-11 or RJ-45 connection. Plug the 10BASE-T network connection
into the surge protection jack labeled “IN” on the back of the
Powerware 9120. Plug the protected equipment into the surge protec-
tion jack labeled “OUT.” Network cabling is not provided. This connec-
tion is optional. It is not needed to use the Powerware 9120.
Do not use this connection for modems or telephones
7
Please fill out the warranty registration card in Section 10 and return it to your local
Eaton Powerware office.
Out In
NETWORK SURGE SUPPRESSION
RJ-45 Jacks