Filter
Top Products
User Manual: Elo
®
Tablet
SW602113 Rev C, Page 55 of 59
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
2. If this equipment appears to cause interference with radio or television reception, or any
other device:
a. Verify an emission source by turning the equipment off and on. If you determine that
this equipment is causing the interference, try to correct the interference by using one
or more of the following measures:
I. Move the digital device away from the affected receiver.
II. Reposition (turn) the digital device with respect to the affected receiver.
III. Reorient the affected receiver’s antenna.
IV. Plug the digital device into a different AC outlet so the digital device and the
receiver are on different branch circuits.
V. Disconnect and remove any I/O cables that the digital device does not use.
(Unterminated I/O cables are a potential source of high RF emission levels.)
VI. Plug the digital device into only a grounded outlet receptacle. Do not use AC
adapter plugs. (Removing or cutting the line cord ground may increase RF
emission levels and may also present a lethal shock hazard to the user.)
If you need additional help, consult your dealer, manufacturer, or an experienced radio or
television technician.
III. Specific Absorption Rate
US FCC & Canada IC:
Your mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for
exposure to radio waves (radio frequency electromagnetic fields) adopted by the Federal
Communications Commission (FCC) and Industry Canada (IC). These limits include a
substantial safety margin designed to assure the safety of all persons, regardless of age and
health.
The radio wave exposure guidelines use a unit of measurement known as the Specific
Absorption Rate, or SAR, to measure the amount of radio frequency energy absorbed by the
human body. The United States and Canada have set the allowable SAR limits for mobile
devices to 1.6 W/kg.
Tests for SAR are conducted using standard operating positions with the device transmitting at
its highest certified power level in all tested frequency bands. The highest measured SAR value
under the FCC and IC testing guidelines for your device model is:
BODY SAR (1g) Wi-Fi, Bluetooth: 1.205 W/kg