Filter
Top Products
40
Epsilon Eb Digital Servo Drive Installation Manual
Figure 35: Drive Faults Detected Dialog Box
Resetting Faults
Some drive faults are automatically reset when the fault condition is cleared. Others require
drive power to be cycled or the drive to be “rebooted” to be cleared. If you wish to continue
working in the PowerTools software without resetting the fault, click the Ignore Fault button.
To reset faults that can be reset with the Reset Faults button, simply click the Reset Faults
button in the Drive Faults Detected dialog box or push the Reset button on the front of the
drive where the fault occurred.
Viewing Active Drive Faults
To view all active drive faults, select the View Faults command from the Device menu. The
dialog box displayed is the same as Active Drive Faults dialog box described above.
Rebooting the Drive
To reboot the drive, cycle power or select the Reboot Drive command from the Device menu.
This command reboots the drive attached to the active Configuration Window.
Watch Window
This feature allows you to customize a window to monitor drive parameters which you select
from a complete list of drive parameters. From this window you can watch the parameters you
selected in real time. This feature is only available when you are online with the drive.
Note
You cannot change the values of the parameters while they are being displayed in the
Watch Window. The parameter in the setup screens will look like they have been changed
when they actually have not. To update a parameter, delete it from the Watch Window
selection.