Filter
Top Products
Printer Server Installation 2-21
Reset to Factory Defaults
Before resetting to factory defaults, we recommend that you print out a
configuration page. Two methods can be used to reset the printer server to its
factory defaults.
• Using the status button
− The printer server will reset to factory defaults immediately.
− IP address and subnet mask are reset to NONE (000.000.000.000).
− Non-volatile memory is reset to factory defaults.
• Using a software command
− The printer server will reset to factory defaults when power is cycled.
− IP address and subnet mask are reset to NONE (000.000.000.000).
− Non-volatile memory is reset to factory defaults.
Reset Using Status Button
1) Remove AC power cord from the printer server.
2) Depress status button and hold.
3) Reconnect AC power cord to printer server, then release status button.
Reset Using Software Commands
1) Obtain privileged status.
2) Enter this command:
>
Server>> initialize server delay delay_min default
delay Indicates reintialization will not take place until after a
specified period of time.
delay_min Specifies the time before the server is stopped and
the initialization process begins. The default is 1
minute.
default Resets the server to factory defaults