Filter
Top Products
Printer Server Installation 2-47
Reset to Factory Defaults
Before resetting to factory defaults, we recommend that you print out a
configuration page. Two methods can be used to reset the printer server to its
factory defaults.
• Using switch settings
− The printer server will reset to factory defaults immediately.
− IP address and subnet mask are reset to NONE.
− Non-volatile memory and RAM are erased.
• Using a software command
− The printer server will reset to factory defaults when power is cycled.
− IP address and subnet mask are reset to NONE.
− Non-volatile memory and RAM are erased.
Reset Using Switch Settings
If necessary, review the information at the beginning of this chapter on the
function of each switch. To reset to factory defaults, follow these steps:
1) Remove AC power cord from the printer server.
2) Move switch #1 to the ON position.
3) Reconnect AC power cord to printer server.
4) Move switch #1 to the OFF position.
The printer server will perform its self-test, load operational software, and
reset to factory defaults.